1.
Remove the existing toilet seat.
To access screw, push lid upward
located all the way at the end of
seat with sharp object. Take out
seat by loosening screw and
holding bolt from bottom.
2. Turn off the main water valve.
3. Take out exiting water pipe.
Loosen fill valve just below the
water tank and compression nut
from control valve. Then take out
water pipe by tapping fill valve.
4. Flush down all the remaining
water in water tank.
Installation
1.
Be sure to shut off main valve.
2. Use the supplied hose to
connect the body joint of the main
unit to the
branching valve. tighten the
coupling nuts at the body joint
and the
branch outlet.
3. Be sure not to over tighten
flexible hose at flush tank end.
Use only hand pressure.
4. Using Teflon tape is
recommended.
5. Shield the nozzle with your
hand to protect the water from
spraying too
far during the trial operation.
6. Press the CLEANSING button to
test the water stream.
Cleaning
the Strainer
The
unit will not operate properly if
the strainer is clogged.
Be sure to clean the strainer.
1. Close the shutoff valve.
2. Flush the toilet to empty the
flush tank.
3. Unscrew the nut.
4. Clean the strainer using a
small brush.
5. Re-screw the nut.
6. Open the shutoff valve.
Built-In
water Heater Bidet
CLEANSING
Warm water cleanses the rear area
thoroughly and refreshingly.
60 SECOND AUTOMATIC SHUT-OFF!
WATER
PRESSURE ADJUSTMENT
Water pressure is adjustable to 4
levels,
as desired.
TEMPERATURE
ADJUSTMENT
Water temperature is adjustable to
4 levels.
This model has an electric
built-in water heater.
BUILT-IN
WATER PUMP
A built-in water pump maintains an
even water pressure regardless of
source water pressure.
SPACE
CONSERVING
Its compact and simple design
conserves space.
IT MAY BE INSTALLED ON EITHER
SIDE, BASED ON AVAILABLE SPACE OR
USER PREFERENCE.
Quality
approved by UL
SB-100, Our European model
obtained GS Mark.
It is Practical, Convenient, and
Clean!
