1.
Remove the existing toilet seat.
To access screw, locate the lid at the end
of the seat and push it upward with a
sharp object. Take out seat by loosening
screw and holding bolt from bottom.
2. Turn off the main water valve.
3. Take out exiting water pipe. Loosen
fill valve just below the water tank and
compression nut from control valve. Then
take out water pipe by tapping fill valve.
4. Flush down all the remaining water in
water tank.
Installation
1.
Connect bolt of adapter to the hexagonal
nut of flexible hose.
2. Insert plastic packing into bottom of
adapter as illustrated.
3. Connect 3/8" compression to the
water valve.
Connect 7/8" fill valve to water
tank later to prevent the hose from
twisting.
(It will lower water pressure)
4. Insert the tube of the Bio-Bidet into
adapter with nut as shown, then tighten
it. When tightening adapter, try to avoid
having the fitting bolt addressed directly to
top of water valve.
This will let you turn valve back on
freely later.
5. Now you may connect 7/8" fill
valve to water tank. Use only hand
pressure to tighten it.
6.
Adjust sliding seat hook coupling with
toilet seat at desired position.
7. Place toilet cover on top of Bio-Bidet.
8. hold nut from the bottom while turning
screw from top.
9. Push down and lock screw lid.
Ready?
Go!
Trying your Bio-Bidet for the first time.
Congratulations! Your are ready to use the
Bio-Bidet for the first time.
Be sure to turn water pressure control knob gently
until reaching the desired pressure.
Water pressure control device is only to control
water pressure, not for setting up the duration of
water spray.
Using
1/2" Converter
If
your main water line has 1/2" male
thread instead of 3/8", simply
convert it to 3/8"
using supplied converter.
Simply insert converter in between main
water line hose as illustrated.
have further questions or need assistance?
Contact any of our distributor in you area
or representative at our head office.
We are there to help with your questions.
Trouble
Shooting
If
your spray nozzle is clogged for some
reason,
simply try to move spray outlet up and
down for few times manually.
Connect 7/8" fill valve to water
tank later to prevent the hose from
twisting. 
