SEAT MODELS

  aAce HS Bidet
  aBiffy Bidet
  aBio Bidet
  aBrondell Bidet
  aDaelim Bidet
  aSanicare Bidet
  aToto Bidet New Models
  aYoyo Bidet
 
  BIDET TOILETS
  aToto Neorest
 
  HANDHELD MODELS
  aSanicare 100
  aSanicare 200
  aSanicare 700
  aItalia
  aMini-shower
 
 PORTABLE MODELS
  aTravel Bidet
 
 BATHROOM ACCESSORIES
  aVitamin-C Hand Shower
 

Check the Compatibility Chart





 

Handheld Installation

The hand bidet you have ordered can be installed in a variety of convenient locations; either on the left or right side of the toilet. The only limitations are the length of the hose.

Although we’ve provided the most common fittings, fresh water outlet fittings and sizes will vary. If needed, we suggest that you take your unit to the local hardware store to find the proper size fitting / adapter.

It is also recommended that you install a shutoff valve similar to the picture below. This will allow you to regulate the pressure for your comfort and safety.

INSTALLATION
1. Turn off the valve at the base of the wall as shown in Step 1. 
2. Flush your toilet to drain the water from your toilet tank.
3. Disconnect the hose at the underside of the toilet tank. 
4. Install the T fitting as shown in Step 2. 
5. Attach the valve to the outlet end of the T fitting as shown in Step 3. Wrap the threads using the teflon tape. 
6. Connect the hose to valve by placing the rubber gasket between the nut and the valve. Tighten well. 
7. Attach the hose to rinsing spray body. Be sure to insert the rubber gasket. In some cases two gaskets will be required, depending on the hand bidet. 
8. Using the fastening set, insert the hanger at a convenient height within easy reach as show in Step 4. 
9. Test the rinsing spray to ensure there is no leakage.

STEP 1

STEP 2
STEP 3 STEP4

Note: In some instances the shutoff valve shown in the above images may be different.


USAGE SPECIFICATION
1. Water pressure should be between 0.05-0.30 Mpa (0.5-3.0 Kgf/cm2). This hand bidet is a low-pressure device, and for safety reasons not designed for high-pressure outlets.
2. Do not use toilet cleaners with hydrochloric acid content.
3. Do not use hard brush or steel wool for cleaning. Soft cloth or sponge is recommended to prevent scratch marks.
4. When tools are required for working with sanitary fittings, use thick cloth to prevent scratch marks.
5. When not in use, turn off the valve to avoid leakage.

Troubleshooting

Problem

Checkpoint

Solution

- Cannot close water

1

Disassemble and clean

- Water leaks around water control plate

1

Disassemble and clean

- Water does not flow smoothly

2

Using a cleaning pin by piercing through the hose of the rinsing plate

- No or low water flow

3

Disassemble and clean

Note: The above drawing is representative of several different models. Individual hand bidet units may vary.

 

 

Have questions about our bidet products?
Give us a call at our toll free number 877-852-2823
fax number (661) 263-0706


Copyright © 1999-2007
Bidet-Bath-Fixtures.com a division of NSV Holdings Corporation
3155 East Patrick Lane, Suite #9, Las Vegas, NV 89120, USA

About Us | Privacy Policy | Toilet Measurements