SEAT MODELS
  aAce HS Bidet
  aBiffy Bidet
  aBio Bidet
  aBrondell Bidet
  aDaelim Bidet
  aSanicare Bidet
  aToto Bidet New Models
  aYoyo Bidet
 
  BIDET TOILETS
  aToto Neorest
 
  HANDHELD MODELS
  aSanicare 100
  aSanicare 200
  aSanicare 700
  aItalia
  aMini-shower
 
 PORTABLE MODELS
  aTravel Bidet
 
 BATHROOM ACCESSORIES
  aVitamin-C Hand Shower
 

Check the Compatibility Chart


 

Neorest Bidet
Installation
 
Can I install a Neorest on my existing plumbing?
YES – as long as you have a 12” Rough-in and your water supply is located approximately 11” off-center.

Does the Neorest work with a 10” or 14” rough-in?
NO (not yet).

Do I need special plumbing/wiring to use the Neorest?
NO – the water supply connection is standard ½ inch, and the unit plugs into a standard 120 Volt AC (GFCI (fused)) outlet.

What is the required WATER PRESSURE?
You need a MINIMUM of 20PSI. The MAXIMUM is 80PSI Use a minimum water supply pressure of 10PSI (0.07Mpa) flowing. (Warranty valid only if the water pressure is between 20 and 80 PSI).

I want to install a shelf above the toilet – how much clearance should I have?
Toto USA recommends at least 10” of clearance above the top of the Neorest. 
Note: that this may effect the remote control’s placement in the bathroom.

 


 

 

Have questions about our bidet products?
Give us a call at our toll free number 877-852-2823
fax number (661) 263-0706




 
Copyright © 1999-2007
Bidet-Bath-Fixtures.com a division of NSV Holdings Corporation
3155 East Patrick Lane, Suite #9, Las Vegas, NV 89120, USA

About Us | Privacy Policy | Toilet Measurements